all about wiring diagram

This is the simple Remote control tester circuit diagram. When the remote control is not working, first check the battery before, It may be loss.If it is good,so detect transmit infrared light device.However, because the human eye can not see infrared light,so can not know how good or bad.But the photo transistor can use to detect infrared light. 

This circuit so use this photo transistor is the light receiver from the remote control.If it is nice to have the bias current of the transistor BC558.It runs a current flows through the LED,so the LED bright.The remote control that works correctly. The variable resistor VR1 is used to adjust the sensitivity of the circuit.

 

This simple Telephone Record Control Circuit Diagram will allow you to connect any tape recorder that has a mic and remote input to a phone line and automatically record both sides of a conversation when ever the phone is in use. You will need to take a couple of voltage readings before connecting the circuit. First determine the polarity of your phone line and connect it to the circuit as shown and then determine the polarity of the remote input and connect it to the circuit.

Circuit operation is as follows. When the phone is on hook the voltage across the phone line is about 48volts dc. When the phone is off hook the voltage will drop to below 10volts dc. When the line voltage is at 48volts the FET is off which causes Q2 and Q3 to be off. When the phone is picked up the FET turns on along with Q2 and Q3 which turns your recorder on. The tape recorder must be in the record mode at all times. As you can see the power source for the circuit is the phone line.